 | | Re: This sweatshirt —David Koudys
|
| | | (...) <snip> (...) I'm not a whiz where electronics are concerned, but I can put batteries in the RCX and test voltages across the breadboard... No, it's pretty much dead. I took the train wall wart, unsoldered the the adapter off a train (...) (21 years ago, 22-Dec-03, to lugnet.org.ca.rtltoronto)
|
| | | |
| | | | | Re: This sweatshirt —Calum Tsang
|
| | | | | (...) a) isn't the Train 9V transformer putting out 9-11V AC? b) does the 2.0 RCX have the rectifier to turn AC into DC? Calum (21 years ago, 22-Dec-03, to lugnet.org.ca.rtltoronto)
|
| | | | | |
| | | | | | | Re: This sweatshirt —David Koudys
|
| | | | | | (...) Well this I did not consider 'cause I use the train wall-wart to plug in my old 1.0's. As far as I knew the train adapter is 9v DC 'cause that's what the train motors are. Then again, my limited electronic knowhow factors in here. Dave K -who (...) (21 years ago, 22-Dec-03, to lugnet.org.ca.rtltoronto)
|
| | | | | | |
| | | | | Re: This sweatshirt —Chris Magno
|
| | | | (...) Dave, Calum is correct, if you used the LEGO train adapter to send "stuff:" to the battery terminals, then YES, you did PUNCH your RCX. now, before Calum pipes up and suggests you put MILK in your RCX, please do bring it to the dinner, I'm (...) (21 years ago, 22-Dec-03, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: This sweatshirt —David Koudys
|
| | | | | (...) <snip> (...) I was thinking Mathias! But haven't seen him in such a long time :( Anyway, it's an attractive paperweight... Dave K -who will adamantly not put milk into his RCX, recalling the time when some sister of his poured coke into his (...) (21 years ago, 22-Dec-03, to lugnet.org.ca.rtltoronto)
|
| | | | | |
| | | | | | Re: This sweatshirt —Calum Tsang
|
| | | | (...) I think Dave now takes the cake for "Most Confused About Electricity" from Shane, creator of Electron-B-Gone. At most you're out $50-130 for a used or new RCX. Calum (21 years ago, 22-Dec-03, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: This sweatshirt —David Koudys
|
| | | | (...) I make bad assumptions at times--if the 9v adapter works for my current 1.0 RCX, and the 9v adapter works for my LEGO 9v DC motors, I assumed that the adapter was 9v DC. As such, I should just be able to use that 9v adapter for my 1.5 and 2.0. (...) (21 years ago, 22-Dec-03, to lugnet.org.ca.rtltoronto)
|
| | | | |
