| |
Mike Stanley wrote:
>
> Larry Pieniazek <lar@voyager.net> wrote:
> > You'd get in because you had good intentions. But then you'd be given
> > tasks where you could not hurt yourself, because what I actually NEED
> > scads of are the 1.2l pins (technic loose pin on one side, open top stud
> > on the other)
>
> I'll try to find it, but if you can give me an LDraw part # for this
> I'll hold any I come across in breaking up sets for you.
I believe it's this one:
http://home.att.net/~partsref/images/4274.gif
> > I have a standing offer on those, as well as on 1x2 tilting top hinges
> > any color. if you have these in large quantities, I want them and will
> > pay better than the going rate for them.
>
> Hrmmm... any color, but only the top half. Ok.
Whoops? I want both halves. It's a tilting-top hinge... I just hate
hyphens so I omitted it. so I want the top and bottom halves of the
tilting top hinge. Any color, but black is preferred.
--
Larry Pieniazek larryp@novera.com http://my.voyager.net/lar
- - - Web Application Integration! http://www.novera.com
fund Lugnet(tm): http://www.ebates.com/ ref: lar, 1/2 $$ to lugnet.
NOTE: Soon to be lpieniazek@tsisoft.com :-)
|
|
Message has 1 Reply:
Message is in Reply To:
178 Messages in This Thread:
(Inline display suppressed due to large size. Click Dots below to view.)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
