|
----- Original Message -----
From: "Alan Carmack" <amenpage@earthlink.net>
To: <lugnet.market.shopping@lugnet.com>; <lugnet.robotics.rcx.nqc@lugnet.com>
<snip>
> Or where can I get such a piece, and the following:
>
> 1 x Technic Plate 1 x 8 with Holes
> 1 x Plate 1 x 8 (Offset 1/2 Stud!) --never knew such an offset piece
> existed
> 1 x Plate 1 x 6 (Offset 1/2 Stud!) -- " "
It looks to me that these last two pieces aren't offset by 1/2 a stud, they are
sitting on a Technic 1 x N plate with rounded ends, but it is inserted 1/2 a
stud off, that is the PINS in the bottom of the 1 x 8 plate are sitting in the
"hollow" studs of the technic 1 x N plate with rounded ends.
See pictures of steps 6 & 7 on this page:
http://homepages.fbmev.de/bm957542/Robotics/SmallKilloughPlatform/index.html
-Andy Lynch
|
|
Message has 1 Reply:
Message is in Reply To:
7 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|