Subject:
|
Re: Anyone seen/baught a PAB Tub?
|
Newsgroups:
|
lugnet.market.shopping
|
Date:
|
Wed, 30 May 2007 04:56:36 GMT
|
Viewed:
|
6126 times
|
| |
|
|
In lugnet.market.shopping, Timothy P. Smith wrote:
> In probably varies from store to store, and with the individual situation. I
> was in Denver not too long ago, and stopped at the Lego store. Three PAB
> cups in two visits- nobody cared that I was taking my time. I didn't stack
> the parts, I wasn't buying ordinary bricks- but I did a lot of tapping and
> filling. Topped off each cup to fill the stud in the lid. And none of the
> lids would snap on and stay, but all three were close (they had a big roll
> of tape at the register, I guess it's a common situation).
The one time I've bought from PAB, I did manage to get both cups (one of each
size) shut to where the lids would stay snapped in place, even after going so
far as to stack a small pile in the center to fill the stud. They taped both of
them shut anyways. My guess is that they're concerned about the customers
possibly dropping them on the way out of the store/mall. Those lids will not
stay attached when dropped with a full load, and a large cup will probably send
parts flying over a few dozen square feet minimum.
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Anyone seen/baught a PAB Tub?
|
| (...) In probably varies from store to store, and with the individual situation. I was in Denver not too long ago, and stopped at the Lego store. Three PAB cups in two visits- nobody cared that I was taking my time. I didn't stack the parts, I (...) (17 years ago, 30-May-07, to lugnet.market.shopping)
|
24 Messages in This Thread:
 
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
