| |
In lugnet.technic, Max Maxwell wrote:
| |
Not sure where I should post this, so I’m just sorta guessing here as to
where to post. Whatever gets me an answer, I suppose. So here goes. Does
anyone have a good, strong, and small (emphasize strong)(similar in
size to the original) solution to incorporating a differential in the front
suspension setup of the 8448 to drive the front wheels? I want it to look
very much the same as the setup described in the 8448 instructions, with the
wheels and steering rack in the exact same location. The width can be made
2-4 studs wider. I am open to any ideas, preferably using the 8466 hubs. But
I will still take no-special-parts solutions. As long as it works and meets
the above requirements. All my ideas and experiments tend to lead either to
strong yet large, or small yet weak setups, and I now seem to be out of
ideas. Please help/guide/assist/suggest!!!!!
Max
|
hi max
I think you should try visit my homepage, I have made a 4x4 some years ago
my page is : WWW.VINTERMUSSEN.DK
I hope You like what you see
Regards Lars Vinter Rasmussen
|
|
Message is in Reply To:
 | | 8448 All-Wheel Drive
|
| Not sure where I should post this, so I'm just sorta guessing here as to where to post. Whatever gets me an answer, I suppose. So here goes. Does anyone have a good, strong, and small (emphasize strong)(similar in size to the original) solution to (...) (21 years ago, 5-Jun-03, to lugnet.technic, lugnet.build, lugnet.cad, lugnet.general, FTX)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
