| |
Not sure where I should post this, so I’m just sorta guessing here as to where
to post. Whatever gets me an answer, I suppose. So here goes. Does anyone have a
good, strong, and small (emphasize strong)(similar in size to the
original) solution to incorporating a differential in the front suspension setup
of the 8448 to drive the front wheels? I want it to look very much the same as
the setup described in the 8448 instructions, with the wheels and steering rack
in the exact same location. The width can be made 2-4 studs wider. I am open to
any ideas, preferably using the 8466 hubs. But I will still take
no-special-parts solutions. As long as it works and meets the above
requirements. All my ideas and experiments tend to lead either to strong yet
large, or small yet weak setups, and I now seem to be out of ideas. Please
help/guide/assist/suggest!!!!!
Max
|
|
Message has 1 Reply:
2 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
