 | | Re: Engine 71 - New Fire Truck
|
| (...) retaining the essential utilitarian look. For the ladder on the side, I managed to get a not bad result by using 1x3 technic liftarms and flex tubes on my skip truck: (URL) was inspired by the ladder on Rosco's tower crane which used axles (...) (23 years ago, 13-Nov-01, to lugnet.general, lugnet.build, lugnet.town)
| | | | | Re: Engine 71 - New Fire Truck
|
| (...) went with the 1x16 beams because of how the ladder hangs off the side of the truck. Basically there are two 1x2 hinge bricks set into the side of the truck, at the level of the top of the back wheel. Attached to each hinge brick is a 1x2 plate (...) (23 years ago, 14-Nov-01, to lugnet.general, lugnet.build, lugnet.town)
| | | | | Re: Engine 71 - New Fire Truck
|
| (...) the (...) at (...) them. Sounds great, although with the flex tube ladder all you need are a couple of 1x1 plates with clips and you're sorted ;-) Jennifer (23 years ago, 14-Nov-01, to lugnet.general, lugnet.build, lugnet.town)
| | | | | Re: Engine 71 - New Fire Truck
|
| (...) Regards ROSCO (23 years ago, 14-Nov-01, to lugnet.general, lugnet.build, lugnet.town)
| |
