 | | Re: How to get apart that structure?
|
|
(...) See (...) I'll add my 2c. I'd be trying to lift one of the "outside" 1x6 beams off the 1x2 plates, just enough to slide it off the #3 axle. If that fails, use some thin-nosed pliers to remove one of the axles. ROSCO (24 years ago, 28-Mar-01, to lugnet.general)
|
| |
| | Re: How to get apart that structure?
|
|
(...) Yes, I've done similar things by accident a few times and usually I bailed out exactly that way, using the flexibility of the pieces in order to "slide" them off the studs they are on. Theoretically, though, I think this structure could not be (...) (24 years ago, 28-Mar-01, to lugnet.general)
|
| |
| | Re: How to get apart that structure?
|
|
(...) I put one of these together (using a 4 axle on one corner for qucik release because I am a coward) and I have found that if you put a thumb behind the middle of one of the horizontal beams and just pull very hard there is just enough (...) (24 years ago, 29-Mar-01, to lugnet.general)
|
| |
| | Re: How to get apart that structure?
|
|
(...) Oh hell! I've just discovered that if you do my modification one quick release axle is not enough. I can't get it apart!!! (24 years ago, 29-Mar-01, to lugnet.general)
|
