| |
I got done posting the curved bridge(s) on Brickshelf not too long ago,
check out http://www.brickshelf.com/cgi-bin/gallery.cgi?f=2572 to catch a
look. This time all the images fall within a reasonable viewing range of
512x384. There was one overhead I would like to have put up but I'll try
later. I should note the design up now are of a second generation and I
will be posting the first gen in the same file.
Ok, you're asking, how did I build it? Well I had to get out the paper and
drafting equipment for this one. It took some time to get everything to fit
just right and I admit to doing some squeezing to get everything to fit but
it works! One element I found very useful are the plate hinges that some
sets like the 8880 supercar or 8480 space shuttle come loaded with. I
should note a 90 degree arc requires 20 of them. You could use the block
type as a substitute in some areas but I haven't tried it, yet!
Yea, yea, I know I put some shots of the straight bridge in there, but the
two have to connect at some point.
Adrian
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
