| |
I've got 3 train plates (6x28 I think), which have a permanent bend in them
[one has the long sides flexed out a bit], and I was wondering how I should
go about straightening them out.
Benjamin Whytcross
BWhytcro@PacificAccess.com.au
|
|
Message has 1 Reply:
 | | Re: Part repairs
|
| Either of these methods has some risk. Lay the plate on a peice of glass in the sun. It should flatten in a few hours. Cool it while it is still on the glass. This one is a little riskier, Lay the plate on a flat dish with a small amount of water (...) (25 years ago, 8-Apr-00, to lugnet.trains, lugnet.general)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
