|
|
 | | Re: Base plate thickness?
|
| (...) Baseplates are exactly the right thickness, such that if they are resting on studs, their studs are exactly 1 plate higher. So I guess that makes them 1 plate minus the height of a stud 8?) ROSCO (17 years ago, 4-Feb-08, to lugnet.general)
| | | | | Base plate thickness?
|
| Hi all, I have this hankering to know the thickness of a baseplate. Not a regular plate, but a baseplate. I found the FAQ page with dimensions of bricks and plates and studs ( www.lugnet.com/~330/...dimensions ) but cannot seem to find out how thick (...) (17 years ago, 4-Feb-08, to lugnet.general)
| | | | | Re: Power Functions infra-red RC protocol released!
|
| In lugnet.general, Jason J Railton wrote: <snip> (...) I'm runnign Dick Swan's alternate firmware that he sent me a while back. Dave K (17 years ago, 4-Feb-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
| | | | | Re: Power Functions infra-red RC protocol released!
|
| (...) I doubt that's possible - a bytecode program just can't run fast enough to do the timing for the IR commands, on either brick. The NXT can only manage it because it sends them over a slow comms link to a HiTechnic IRLink sensor, then that (...) (17 years ago, 3-Feb-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
| | | | | Re: Power Functions infra-red RC protocol released!
|
| (...) <snip> Nicely done John! Is there a tentative timeframe when NQC for the RCX will be updated to support IR to the LEGO powerfunctions? Dave K (17 years ago, 2-Feb-08, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
|
|
