Subject:
|
autoFAQpost /general/howto_get_wax_off.en.faq
|
Newsgroups:
|
lugnet.faq
|
Date:
|
Mon, 12 Jul 1999 23:33:25 GMT
|
Viewed:
|
1444 times
|
| |
|
|
Subject: How can I remove candle wax from my LEGO® pieces?
Topic-Level: 1
Content-Language: en
Originator: Eric Joslin, 1999-03-06
Revision: Kevin Wilson, 1999-03-06
Revision: Gary Istok, 1999-03-08
Revision: Beth Reiten, 1999-03-11
Reference: http://www.lugnet.com/news/display.cgi?lugnet.general:3100
Reference: http://www.lugnet.com/news/display.cgi?lugnet.general:3120
Reference: http://www.lugnet.com/news/display.cgi?lugnet.general:3157
Location: /general/
<P><I>From Kevin Wilson:</I></P>
<P> Put it in the freezer, which will make the wax very brittle and it
should come off much easier. </P>
<P><I>From Gary Istok:</I></P>
<P> First freeze and then break away the large pieces. Then try using
discarded women's panty hose/nylons to scrub away the wax. Panty hose
should not scratch the LEGO. </P>
<P><I>From Beth Reiten:</I></P>
<P> I'd strongly agree with the freezer folks, with one minor addition.
While still cold, if it looks like you're going to have a dye mark
problem, try some baby oil on a tissue directly on the dye mark. Oil
picks up wax soluble dye quite well... if it's on something that can
handle oil (I don't recommend this technique on the latex paint in your
house!) </P>
<P> The problem with heat is that most candle waxes -- other than the 100%
paraffin used in tea lights -- is that the lowest temperature that it'll
melt at is around 125 - 150 F. Sounds like that's too high for Legos!
</P>
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
