 | | Re: Helfire - a microfig scale castle town
|
|
(...) Shiri, Super job, I really like your little-big town :-). Great job documenting the roof and doing a corner peek. I do think you have seen them before though but just not as close up and obvious, my Inn does have 2 corners like this one is in (...) (25 years ago, 29-Mar-00, to lugnet.castle)
|
| |
| | Re: Helfire - a microfig scale castle town
|
|
Shiri: (...) There is no doubt about what it is, although the church could use a "slightly" smaller cross. Play well, Jacob ---...--- -- E-mail: sparre@cats.nbi.dk -- -- Web...: <URL: (URL) > -- ---...--- (25 years ago, 29-Mar-00, to lugnet.castle)
|
| |
| | Re: Helfire - a microfig scale castle town
|
|
(...) No, don't say it: you are (searching for subtle euphemism) "passing" bricks? Oooooo, and you have to use a brick separator? Ouch. You are taking this Lego stuff too far! :-) Bruce (25 years ago, 29-Mar-00, to lugnet.castle)
|
| |
| | Re: Helfire - a microfig scale castle town
|
|
(...) Well, I only have three, but I usually find that one of them is lost in the pile of junk mail on the desk. I try to keep them all together so I don't have to build any contraptions to get the 1x2 plate stack apart. John (25 years ago, 29-Mar-00, to lugnet.castle)
|
| |
| | Re: Adding height to minifigs?
|
|
I had to do this for my Charles Degaulle (?) figure for my Eiffel Tower. I stuck a 2x4 'camera' brick with studs on 4 sides and a tube on the end in between the body and legs. I also put a 1x1 plate on the bottom and a 1x2 plate on that for feet. (25 years ago, 29-Mar-00, to lugnet.castle)
|
