To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.castleOpen lugnet.castle in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Castle / 20255
20254  |  20256
Subject: 
Re: A slice of tudor
Newsgroups: 
lugnet.castle
Date: 
Fri, 3 Sep 2004 13:24:51 GMT
Viewed: 
3292 times
  
In lugnet.castle, Jason Spears wrote:
   In lugnet.castle, Larry Pieniazek wrote:
   In lugnet.announce.moc, Jason Spears wrote:
   Another house, along the same lines as my corner house that I announced earlier in the week. This one is quite a bit smaller, if a brick or so taller.

How thin IS it? I get something like 3 studs in back? That may be a LITTLE too thin... :-)

Yeap, 3 studs in back. I wanted to go thinner, but the bricks didn’t seem to want to work well that way. It’s cozy inside, not cramped.

   I like the way this is going though! Next you need to make one that is concave instead of convex!

On my to do list. I’m pondering some smaller, but flatsided buildings to go along with them, but yeah, before CKM, I should have a good selection done.

I think it may be helpful to have the final assortment be some multiple of 90 degrees when you add up all their angles, so that they can be used to make a tight block that doesn’t have any angle gaps.

I may look to making sure some of my buildings have flat faces, or maybe even build one or two small (low) flat sided buildings. If you put a low flat against a higher one with roof overhang it should still allow you to nestle them right up against each other.
  
Jason Spears | BrickCentral | MichLUG



Message has 1 Reply:
  Re: A slice of tudor
 
(...) I'm not sure that's necessary or even possible. First it would require me to figure out what angles I already have, I don't know this, nor did I think it was important. Second then I would feel constrained to build more just to achieve this (...) (20 years ago, 4-Sep-04, to lugnet.castle, FTX)

Message is in Reply To:
  Re: A slice of tudor
 
(...) Yeap, 3 studs in back. I wanted to go thinner, but the bricks didn't seem to want to work well that way. It's cozy inside, not cramped. (...) On my to do list. I'm pondering some smaller, but flatsided buildings to go along with them, but (...) (20 years ago, 3-Sep-04, to lugnet.castle, FTX)

8 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR