Subject:
|
Re: 2x4 Brick Renders
|
Newsgroups:
|
lugnet.cad.ray
|
Date:
|
Mon, 19 Mar 2001 16:49:00 GMT
|
Viewed:
|
1863 times
|
| |
|
|
In lugnet.cad.ray, Micah J. Mabelitini wrote:
> I recently rendered a few scenes of the 2x4 brick in Bryce 4. The brick
> model is original and accurately proportioned. Although I did leave out
> a few miniscule details of the modern 2x4 brick, nothing larger than
> .1mm was omitted. The bricks in all of the scenes are rendered
> translucently to reveal more detail of the model. You can view the
> scenes at:
>
> http://www.users.kih.net/~micahx/one.jpg
> http://www.users.kih.net/~micahx/two.jpg
> http://www.users.kih.net/~micahx/iblocs.jpg
>
> The images are all 1024x768 pixels, and range from about 70-100K in size.
Wow! Very cool. :)
One detail you did leave out, although I haven't measure its size, is the
rounded edges of the bricks (studs should be even more rounded than the
rest of the brick). It's a pain to add, but it would add a lot to the
rendering.
Steve
|
|
Message has 1 Reply:
 | | Re: 2x4 Brick Renders
|
| (...) Yeah, I left out the rounded edges, the very shallow 90 degree cut-out on bottom of the inside wall, some horizontal raised ridges on the inside wall, and the four convex bulges on the inside walls of the tubes. The latter three were merely (...) (24 years ago, 19-Mar-01, to lugnet.cad.ray)
|
Message is in Reply To:
| | 2x4 Brick Renders
|
| I recently rendered a few scenes of the 2x4 brick in Bryce 4. The brick model is original and accurately proportioned. Although I did leave out a few miniscule details of the modern 2x4 brick, nothing larger than .1mm was omitted. The bricks in all (...) (24 years ago, 19-Mar-01, to lugnet.cad.ray, lugnet.general)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
