To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.rayOpen lugnet.cad.ray in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Ray-Tracing / 1812
1811  |  1813
Subject: 
Re: Create only BOM and parts used in LPub
Newsgroups: 
lugnet.cad.ray
Date: 
Fri, 30 May 2003 11:53:18 GMT
Viewed: 
1123 times
  
Yes! Ofcourse. I could have figured that out myself!
Thanks a lot (again) Kevin!

Jaco

"Kevin L. Clague" <kevin_clague@yahoo.com> schreef in bericht
news:HFo229.13qE@lugnet.com...
In lugnet.cad.ray, Jaco van der Molen wrote:

Is it possible to just generate part images or the BOM image, without • having
to render the complete model?

  Go to the Building Instructions tab, then the Steps sub-tab.  Uncheck • the
Construction Images check box.



Message is in Reply To:
  Re: Create only BOM and parts used in LPub
 
(...) Hi Jaco, I'm doing this from memory because I don't have LPub in front of me, but.... Go to the Building Instructions tab, then the Steps sub-tab. Uncheck the Construction Images check box. Pull down the Generate->Instruction Images menu. (...) (21 years ago, 29-May-03, to lugnet.cad.ray)

3 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR