 | | Re: MLCAD introductory info —Jake McKee
|
| | | (...) You are right. That is absolutely what it did. I went through my sub models one by one to: - Create a comment line telling me where each submodel started - Opened both the master file and the submodel file in Notepad - Copied the submodel (...) (23 years ago, 11-Jun-01, to lugnet.cad.mlcad)
|
| | | |
| | | | | Re: MLCAD introductory info —Bram Lambrecht
|
| | | | (...) program (...) The Inline function in LDAO (by Steve Bliss) takes all the referenced subfiles in a DAT file and merges them into one file by transforming the parts. However, with the popularity of MPD, fewer people are inlining than they used (...) (23 years ago, 11-Jun-01, to lugnet.cad.mlcad)
|
| | | | |
| | | | | | Re: MLCAD introductory info —Daniel Crichton
|
| | | | "Bram Lambrecht" <bram@cwru.edu> wrote in message news:004301c0f280$9a...erv.net... (...) I new there was something that already did this, but I couldn't remember what it was. Guess I'll have to look at using LDAO again to make this easier. One (...) (23 years ago, 11-Jun-01, to lugnet.cad.mlcad)
|
| | | | |
