To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.mlcadOpen lugnet.cad.mlcad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / MLCad / 386
    Re: Doing Patterns and Bitmaps in MLCad —Travis Cobbs
   "Steve Bliss" <steve.bliss@home.com> wrote in message news:oekarsonpfetb7s...4ax.com... (...) I tend to agree about putting it all in 2 separate commands. However, I don't think a position vector and orientation matrix are appropriate. A texture is (...) (24 years ago, 6-Sep-00, to lugnet.cad.mlcad, lugnet.cad.dev)
   
        Re: Doing Patterns and Bitmaps in MLCad —Steve Bliss
   (...) You are right. My approach assumed to much and restricted too much. (...) Good point. (...) OK. (...) Right. But if START is required, then it might as well be omitted. My purpose in having an optional START was to allow TEXTUREs without the (...) (24 years ago, 6-Sep-00, to lugnet.cad.mlcad, lugnet.cad.dev)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR