 | | MLCAD not working... —Markham Carroll
|
| | | I am getting the error "Invalid path (no Parts and/or P dir found)!" The program has been working for months, and all of a sudden I'm getting this. The P and Parts directories are in the same folder, and the parts.lst is there too. What is going (...) (22 years ago, 20-Aug-02, to lugnet.cad.mlcad)
|
| | | |
| | | | | Re: MLCAD not working... —Orion Pobursky
|
| | | | (...) Try this: In MLCad, go to Settings->General->Change... Check and make sure the Lego Base Path is the directory where you have LDraw installed. -Orion (22 years ago, 20-Aug-02, to lugnet.cad.mlcad)
|
| | | | |
| | | | | | Re: MLCAD not working... —Markham Carroll
|
| | | | "Orion Pobursky" <bilthefish@IHATESPAMyahoo.com> wrote in message news:H15HKz.3o4@lugnet.com... (...) this. (...) LDraw (...) I can't start MLCAD, but the error message lets me change the path. It still doesn't work. -- Markham Carroll (22 years ago, 20-Aug-02, to lugnet.cad.mlcad)
|
| | | | |
| | | | | | Re: MLCAD not working... —Markham Carroll
|
| | | | | "Markham Carroll" <mc_booga@hotpop.com> wrote in message news:H15Iu8.86y@lugnet.com... <snippet> Um... I found out what was wrong. I used to have two hard drives in my computer, and when I took the old one out, the drive letters changed and my (...) (22 years ago, 21-Aug-02, to lugnet.cad.mlcad)
|
| | | | | |
| | | | | | Re: MLCAD not working... —Michael Lachmann
|
| | | | When you are on a NT system make sure you have access to that path and that you can write to the registry. On XP this requires admin rights - or to be the owner of the computer. Michael "Markham Carroll" <mc_booga@hotpop.com> wrote in message (...) (22 years ago, 21-Aug-02, to lugnet.cad.mlcad)
|
| | | | |
