|
|
 | | zoom function
|
| Is there a way to set up MLCAD so that when I do a zoom in, say change from 100 percent view to 300 percent view, to have the view centered on the part that is currently selected? It is a minor thing, but something that i would like to be able to (...) (25 years ago, 5-Jun-01, to lugnet.cad.mlcad)
| | | | | Re: Differences between rotation points
|
| (...) from (...) library (...) rotation (...) That helps a lot. Thanks! Cheers, --Ryan (25 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
| | | | | Re: Maximum Coarse movement
|
| (...) Shure, I will take care on that. In the mean time you could move the part using the mouse and a small scale factor in the viewing pane. That should help a little bit. Michael (25 years ago, 30-May-01, to lugnet.cad.mlcad)
| | | | | Re: Differences between rotation points
|
| (...) - Part Origin, is the absolute zero (0,0,0) point of the part itself. - Part Center, is the computed center of the part (e.g. the part ranges from (-2, -2, -2) to (+4, +4, +4) so the computed center is (+1,+1,+1). - The part rotation point, is (...) (25 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
| | | | | Maximum Coarse movement
|
| Michael, Why is the Maximum Coarse movement limited to 100? If one is moving pieces long distances frequently, using the Enter Position/Rotation dialog box can become tiresome. Could you perhaps increase the limit to, say, 250 or so? Regards, --Ryan (25 years ago, 29-May-01, to lugnet.cad.mlcad)
|
|
