| | Re: Suggestion for MLCad Plug-Ins
|
|
(...) I like that idea. (...) Yep. The idea is for LDAO to be both a source and sink for dragged parts. (...) Two approaches: 1. Allow multiple formats for the string being passed in the WM_COPYDATA message. One format is the one you're already (...) (25 years ago, 2-Feb-00, to lugnet.cad.mlcad, lugnet.cad.dev)
|
|
| | Re: Best hardware for MLCad?
|
|
(...) Ok here are the real minimum hardware requirements for MLCad (V1.7 Release 2): - Any computer running with Windows 95/98 or NT - Harddisk mainly depends on the operating system plus arround 100 MB (for dat files and swap-space) - Graphic card (...) (25 years ago, 1-Feb-00, to lugnet.cad.mlcad)
|
|
| | Re: Best hardware for MLCad?
|
|
It will probably work but you will HATE it at that speed. (25 years ago, 1-Feb-00, to lugnet.cad.mlcad)
|
|
| | Re: Best hardware for MLCad?
|
|
(...) As I stated before, the computer is a 486 66MHz. It has 8MB of RAM. Barely enough to run Win95. As far as video and graphics cards, I don't have a clue anymore. I would like to think that I could use it for MLCad, otherwise it's probably (...) (25 years ago, 31-Jan-00, to lugnet.cad.mlcad)
|
|
| | Re: Suggestion for MLCad Plug-Ins
|
|
Steve Bliss skrev i meddelandet ... (...) We'll think about it later... (...) When a (...) Sounds like a good idea - I'll test it when Real Life permits. Will LDAO also allow drag *from* LDAO to xxx? By using the same protocol you could use LDAO (...) (25 years ago, 31-Jan-00, to lugnet.cad.mlcad, lugnet.cad.dev)
|