| |
In lugnet.cad.dev.org.ldraw, Tim Courtney wrote:
> The new ldraw.org logo will be a fade-to-wireframe red brick, similar
> to the one Bram put on his site for a wallpaper, but the standard
> ldraw.org red 2x3 at the same camera angle. Also, they wish us NOT to
> use LDRAW on the studs, instead they would like us to put LEGO, or not
> have any stud detail at all. They also ask that I add a disclaimer to
> our materials stating:
>
> "LEGO, the LEGO logo and the brick configuration are trademarks of the
> LEGO Group. The LEGO Group does not sponsor or endorse this website."
>
> I will add this in fine print to the bottom of the sign, in a
> non-intrusive manner.
>
> At this point, I believe I will run with putting LEGO on the stud
> detail, because a logo of the size it will be on the sign will seem
> bare without any detail. I believe the disclaimer should be
> sufficient, but I will run the LEGO stud detail by the lawyer in the
> morning.
If TLC is OK with putting LEGO on the studs, I think that is great! :)
We're not playing with MegaBloksDraw here.
Is this new wireframe logo just for the sign, or will it eventually go on
ldraw.org as well?
Steve
|
|
Message has 1 Reply:
Message is in Reply To:
 | | ldraw.org Logo Change
|
| Well... In an interesting question and answer session I had originally with Brad Justus, it came to my attention that TLC did not approve of the 3D red brick ldraw.org logo. Brad checked with the corporate counsel about the logo, and relayed the (...) (26 years ago, 29-Jun-00, to lugnet.cad.dev.org.ldraw, lugnet.events, lugnet.cad) !
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
