Subject:
|
Re: Run time error 200
|
Newsgroups:
|
lugnet.cad.dev.org.ldraw
|
Date:
|
Sat, 11 Mar 2000 09:40:54 GMT
|
Viewed:
|
1351 times
|
| |
|
|
In lugnet.cad.dev.org.ldraw, Dennis Osborn writes:
> Hello All
>
> I downloaded ldraw.exe, complete.exe, and rte200fx.exe to my hard drive.
>
> I <start><run>
> c:\ldraw.exe -y
> c:\complete.exe -y
> c:\rte200fx.exe <-- I do run the patch
> c:\ldraw\mklist.exe
>
> Everything appears to expand and run correctly. But when I run
> c:\ldraw\ledit.exe
> I get the Runtime Error 200.
>
> Any suggestions? I am running a Gateway GP6-450.
> I read on ldraw.org that the patch was needed because 200mhz machines
> were outracing a built in delay counter. Could my 450mhz machine be
> ourtracing the patch?
>
> I have also tried copying rte200fx.exe into the Ldraw directory and
> running
> it, but I get the same results.
>
> Dennis Osborn
> osbodr01@holmes.ipfw.edu
Hello,
It's not a problem with the speed of your machine since i run Ledit on a PIII
450 (with rte200fx.exe) and works fine. You should get MLCad. You can find the
homepage at Lugnet/CAD/MLCad. It is an excellent cad program to build your
models.
George
|
|
Message is in Reply To:
 | | Run time error 200
|
| Hello All I downloaded ldraw.exe, complete.exe, and rte200fx.exe to my hard drive. I <start><run> c:\ldraw.exe -y c:\complete.exe -y c:\rte200fx.exe <-- I do run the patch c:\ldraw\mklist.exe Everything appears to expand and run correctly. But when (...) (25 years ago, 10-Mar-00, to lugnet.cad.dev.org.ldraw)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
