To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dev.org.ldrawOpen lugnet.cad.dev.org.ldraw in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / Organizations / LDraw / 565
    Re: Clone DATs--any interest? —Todd Lehman
   (...) OK, here's an analogy... Hopefully this will illustrate the purist's point of view and why it's not arbitrary... You go into a restaurant and order big fat juicy third-pound burger with all the fixings, a side of french fries, and a big tall (...) (25 years ago, 27-Nov-99, to lugnet.cad.dev.org.ldraw, lugnet.off-topic.clone-brands, lugnet.cad.dev)
   
        Re: Clone DATs--any interest? —Larry Pieniazek
   First of all, no one is trying to "pass" any clones as being the real thing. (...) Second, Tyco is NOT "crummy", it's just different. I don't use it but I think you're letting your emotions get in when you toss around "crummy". Tyco made blocks that (...) (25 years ago, 27-Nov-99, to lugnet.cad.dev.org.ldraw, lugnet.off-topic.clone-brands, lugnet.cad.dev)
   
        Re: Clone DATs--any interest? —Todd Lehman
   (...) Disagree. I remember trying it out Tyco in 1988 and it left a very bitter taste in my mouth -- blyecch -- and at the time I wasn't even a LEGO purist. True, Tyco was the best of the non-LEGO off-brands, but the quality still never quite lived (...) (25 years ago, 27-Nov-99, to lugnet.cad.dev.org.ldraw, lugnet.off-topic.clone-brands, lugnet.cad.dev)
   
        Re: Clone DATs--any interest? —Steve Bliss
     (...) I'd say, brickwise, Tyco's biggest problem is they didn't round off the edges of the bricks. You thought it hurt to step on *LEGO* bricks? Those Tyco pieces were doubly painful. Also, the lack of rounding made it hard to pry the pieces apart. (...) (25 years ago, 29-Nov-99, to lugnet.cad.dev.org.ldraw, lugnet.off-topic.clone-brands)
   
        Re: Clone DATs--any interest? —Todd Lehman
   (...) Aha! I don't remember that pain, but that sounds about right! That would certainly explain why that double-tube plate made parts connected to it so difficult to pull apart! :-( --Todd [followups to lugnet.off-topic.clone-brands] (25 years ago, 29-Nov-99, to lugnet.cad.dev.org.ldraw, lugnet.off-topic.clone-brands)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR