Subject:
|
Re: Movement and friction
|
Newsgroups:
|
lugnet.cad.dev.lcd
|
Date:
|
Mon, 11 Feb 2002 22:24:21 GMT
|
Viewed:
|
2492 times
|
| |
|
|
In lugnet.cad.dev.lcd, Barney Hilken writes:
> I was thinking of friction as a simple on/off property: connections with
> friction only move during construction, whereas connections without are free
> to move under gravity or inertia or other forces during animation of the
> final model. Is this too simplistic?
I think it probably is. The situations I'm thinking about are:
1. axles in technic bricks, which fit your "no friction" model;
2. the light grey low-friction pins, which could also fit the "no friction"
model (with regard rotation);
3. the black friction pins, which can rotate in the final model, but with
significantly more friction than 1 or 2 (ie can resist gravity up to a point).
There are probably other cases too, but I think there'd need to be at least 3
levels of friction (low, medium, high) to cover the friction pins (with low &
high corresponding to your off & on settings).
The next tricky thing to model is rubber bands, then comes chains...
ROSCO
|
|
Message is in Reply To:
 | | Re: Movement and friction
|
| I was thinking of friction as a simple on/off property: connections with friction only move during construction, whereas connections without are free to move under gravity or inertia or other forces during animation of the final model. Is this too (...) (23 years ago, 11-Feb-02, to lugnet.cad.dev.lcd)
|
9 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
