 | | Re: New LDraw based editor... GLIDE. Click authors required.
|
|
(...) inline in a valid DAT file? Perhaps make all the lines start with a "0 LCD" before anything else? Then, when reading a DAT file, a program can recognize and parse LCD info, in addition to looking for the .lcd file. Does that make sense? Do you (...) (22 years ago, 22-Jun-04, to lugnet.cad, lugnet.cad.dev.lcd, lugnet.cad.dat.parts)
|
| |
| | Re: New LDraw based editor... GLIDE. Click authors required.
|
|
Hi Glide has been on hold now for about a month but its back in development. You can look forward to clicking bricks in about two to three weeks. Once I have the system implemented is there anyone out there who would be prepared to start writing (...) (22 years ago, 22-Jun-04, to lugnet.cad, lugnet.cad.dev.lcd, lugnet.cad.dat.parts)
|
| |
| | Re: LCD draft spec comment
|
|
(...) If this is a feature that is used deliberately and often enough to motivate a software model for it, it would be possible to encode a combination of hard constraints, demonstrating the normal and preferred connection method, and additional (...) (22 years ago, 22-May-04, to lugnet.cad.dev.lcd)
|
| |
| | Re: LCD draft spec comment
|
|
(...) would find most useful is technic axle in it's hole - there's quite a significant clearance between them. Not sure the best way to handle such things. ROSCO (22 years ago, 22-May-04, to lugnet.cad.dev.lcd)
|
| |
| | Re: LCD draft spec comment
|
|
(...) Hi I am currently working on my own version of LCD. (URL) was thinking of adding some kind over-ride to the angle of movement for each connection. This clinches it, I will. The format itself could hold single-studs that lock at 90 degrees or (...) (22 years ago, 22-May-04, to lugnet.cad.dev.lcd)
|
