| | Re: Symmetries other than 16 and 48?
|
|
"Steve Bliss" <steve.bliss@earthlink.net> wrote in message news:8ljscv8fn458bfv...4ax.com... (...) 73071 (...) and (...) of (...) That makes a lot of sense, especially for segments that would not be used by other parts. (...) I guess that would (...) (21 years ago, 24-May-03, to lugnet.cad.dev)
|
|
| | LDDP open source project: Source code released!
|
|
Hi! I just want everyone to know that I just uploaded the LDraw DesignPad Delphi sourcecode into the CVS branch at (URL) . Please be aware that the sourcecode is offered under the GPL license. Next steps in development will be: - Linux version of (...) (21 years ago, 24-May-03, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)
|
|
| | Re: Symmetries other than 16 and 48?
|
|
(...) For parts with unusual symmetries, I would suggest either (or both): 1. Make a subfile in parts\s with 1 segment of the part, then use that subfile as many times as you need. 2. Find a higher-level symmetry that is common with 16 or 48 (...) (21 years ago, 23-May-03, to lugnet.cad.dev)
|
|
| | [Parts Tracker] Notes for Admins
|
|
Just a quick note for authors & reviewers on the Parts Tracker -- if you need an admin to address something, please email parts@ldraw.org about it -- if you just leave a comment in a review, the admins will only pick up on it by chance. Actually, (...) (21 years ago, 23-May-03, to lugnet.cad.dev)
|
|
| | Re: Is anyone making part 44224.dat?
|
|
The mating part is refered to as 44225 on both Peeron and Bricklink... Philo (...) (21 years ago, 23-May-03, to lugnet.cad.dev, lugnet.cad.dat.parts)
|