 | | Re: Type 5 lines at the edge of primitives
|
|
(...) Hmm... Good point; I hadn't thought of that. But I'll have to check to be sure (it's hard to visualize). The way I currently have my sphere, the joins between the segments are always drawn either twice or not at all. If this does work, though, (...) (22 years ago, 5-May-02, to lugnet.cad.dev)
|
| |
| | Idea, using functions for some primitives.
|
|
I was thinking over this the other day, and thought maybe could be some sort of line type p that would work the same as the type 1 lines, but istead take a function instead of a piece. This would be for primitves that the drawing program replaces (...) (22 years ago, 5-May-02, to lugnet.cad.dev)
|
| |
| | Re: Type 5 lines at the edge of primitives
|
|
(...) I'm not sure if I understand this properly - if the second "test" point is down the line where the cylinder joint (between two rects) would be if it was attached to a cylinder, won't that work? It'll mean the same line may occasionally be (...) (22 years ago, 5-May-02, to lugnet.cad.dev)
|
| |
| | Type 5 lines at the edge of primitives
|
|
I'm not sure if this has been discussed before, but I discovered a problem with the use of type 5 lines at the edge of primitives. The basic problem is that there is no way for the primitive to know which direction any attached polygons are going to (...) (22 years ago, 4-May-02, to lugnet.cad.dev)
|
| |
| | numbers report
|
|
(URL) certified files. 28 files need admin review. 189 files need more votes. 287 have uncertified subfiles. 99 held files. (Total: 623) (22 years ago, 4-May-02, to lugnet.cad.dev)
|
