CAD Development : 6551


CAD / Development / 6551	6550 \| 6552

Subject:	Re: New Part: dome.dat (and a part authoring tool idea)
Newsgroups:	lugnet.cad.dat.parts, lugnet.cad.dev
Date:	Tue, 20 Nov 2001 18:42:38 GMT
Viewed:	74 times

In lugnet.cad.dat.parts, Don Heyse writes: > Well, now that you mention it, there are a few more missing type 5 > lines around the top of the upper dome and the bottom of the lower > dome. You can see the missing upper dome lines here. http://www.brickshelf.com/cgi-bin/gallery.cgi?i=85873 Also there seem to be some type 2 lines that should perhaps be type 5 lines on the undersides of some of the technic pin sockets? You can see a few on the top left part of the picture. Don

Message has 1 Reply:

		Re: New Part: dome.dat (and a part authoring tool idea) [DAT]
(...) Thanks for the thorough review. I think I finally fixed all of the type 2 and type 5 lines. Please let me know if you see any other problems. If you get a chance, please take a look at some of my other parts at: (URL) Technic Dome 6 x 6 x 5 (...) (23 years ago, 21-Nov-01, to lugnet.cad.dat.parts, lugnet.cad.dev)

Message is in Reply To:

		Re: New Part: dome.dat (and a part authoring tool idea)
(...) Well, now that you mention it, there are a few more missing type 5 lines around the top of the upper dome and the bottom of the lower dome. I wish there were better tools around to examine the lines. I've been experimenting with some new (...) (23 years ago, 20-Nov-01, to lugnet.cad.dat.parts, lugnet.cad.dev)

8 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search