To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 6191
  Re: Differences between rotation points
 
(...) - Part Origin, is the absolute zero (0,0,0) point of the part itself. - Part Center, is the computed center of the part (e.g. the part ranges from (-2, -2, -2) to (+4, +4, +4) so the computed center is (+1,+1,+1). - The part rotation point, is (...) (23 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)
 
  Re: Differences between rotation points
 
(...) from (...) library (...) rotation (...) That helps a lot. Thanks! Cheers, --Ryan (23 years ago, 30-May-01, to lugnet.cad.dev, lugnet.cad.mlcad)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR