 | | Re: Modelling !
|
| (...) This is only an approximation. The LEGO bricks are not metric -- The dimensions are based on inches. The width of one brick is 5/16 inch and the height (without studs) is 6/16 inch. So 0.39370mm = 1LDU is more precise. I normally try to (...) (24 years ago, 10-Jun-00, to lugnet.cad.dev)
| | | | | Re: Modelling !
|
| (...) But 0.4mm = 1 LDU (also known as 1mm = 2.5 LDU) is for us Metrics a solid enough basis to model parts with. Greetings, M. Moolhuysen (24 years ago, 10-Jun-00, to lugnet.cad.dev)
| | | | | Re: Modelling !
|
| (...) For large LEGO elements, the difference would probably be significant, so I would suggest using 0.3937mm = 1LDU. But it's normally better to measure new elements along long LEGO beams, when applicable. Fredrik (24 years ago, 10-Jun-00, to lugnet.cad.dev)
| | | | | Re: Modelling !
|
| (...) It's definitely closer to 25.6cm x 25.6cm than 10' by 10'! I think you meant 10" by 10" :-) --Todd (24 years ago, 10-Jun-00, to lugnet.cad.dev)
| | | | | Re: Modelling !
|
| (...) Oh no! I did the same misteak as the guys in "The Spinal Tap"! (They ordered a scene prop at 18" by 18", but meant 18' by 18'.) The next thing you'll know, I'll probably be buying amplifiers which go to eleven. (FU: lugnet.off-topic.fun) (...) (24 years ago, 11-Jun-00, to lugnet.cad.dev, lugnet.off-topic.fun)
| | | | | Re: Modelling !
|
| (...) I'm not sure that would prove anything -- baseplates are trimmed slightly smaller than the full stud-pitch. If you join two baseplates with bricks or plates on top, there will be a slight gap between the two baseplates. Now, taking those two (...) (24 years ago, 12-Jun-00, to lugnet.cad.dev)
| |
