 | | Re: Help for povray needed!
|
|
(...) <SNIP> Thanks, this helps a lot, but now there is one problem left: MLCad first creates the dat file to be converted, than calls L3P to convert it into pov and than it executes pov-ray with the above statement. If you do that for multiple (...) (24 years ago, 19-Apr-00, to lugnet.cad.dev)
|
| |
| | Re: Help for povray needed!
|
|
(...) There are a couple of ways around this. One is to write all the POV-Ray commands to a .BAT file, using the START command with its /WAIT option. After compiling all the needed files, run the .BAT file. Another way is to launch POV-Ray, then put (...) (24 years ago, 19-Apr-00, to lugnet.cad.dev)
|
| |
| | Re: Help for povray needed!
|
|
In lugnet.cad.dev, Steve Bliss writes: <SNIP> Thank you steve! Over the week-end I had more time, and found exactly the same way, just in C++. But (how should it be different) there is another problem ... This works fine for pov-ray, with L3P this (...) (24 years ago, 23-Apr-00, to lugnet.cad.dev)
|
| |
| | Re: Help for povray needed!
|
|
Michael Lachmann skrev i meddelandet ... (...) which (...) If you create a shortcut for L3P (and start _that_ from MLCAD), you can set the 'Close Window on Exit' flag in the shortcut. -- Anders Isaksson, Sweden BlockCAD: (2 URLs) (24 years ago, 23-Apr-00, to lugnet.cad.dev)
|
| |
| | Re: Help for povray needed!
|
|
(...) about this trick. Michael (24 years ago, 24-Apr-00, to lugnet.cad.dev)
|
