|
|
 | | Re: LPub DPI control?
|
| (...) I just found the following in my VB description: 1440 Twips = 1 inch 1 Twips = 1/20 point (DTP) 1 cm = 567 Twips 1 point = 0,3515 cm (72 dpi) maybe this is also useful. cu mikeheide (17 years ago, 5-Mar-08, to lugnet.cad.dev)
| | | | | Re: LPub DPI control?
|
| In lugnet.cad.dev, Kevin L. Clague wrote: SNIP (...) Maybe the following link does help you a little bit: (URL) you use truetype fonts it should not be a problem to print them in the correct size. cu mikeheide (17 years ago, 5-Mar-08, to lugnet.cad.dev)
| | | | | Re: LPub DPI control?
|
| (...) Most of this feature is done. I had to identify every LPub meta-command that had something with the units of pixels, and treat them as a new class of "units", meaning known absolute distances (i.e. meters or inches.) Every time these values (...) (17 years ago, 5-Mar-08, to lugnet.cad.dev)
| | | | | Re: LPub DPI control?
|
| (...) Hi Remi, I'm working on DPM and DPI now. Here is what I plan on doing: You set the page size in either inches or centimeters. You define the resolution in terms of DPI or DPM. You control the magnification. For example, if I have a 1 inch page (...) (17 years ago, 4-Mar-08, to lugnet.cad.dev)
| | | | | Re: Seam width in LDView
|
| (...) It applies it to everything that it considers to be a part, but not a sub-part. A sub-part is any sub-file (or sub-sub-file, etc) of something that is determined to be a part. Adding an unofficial part header is the easiest way to convince (...) (17 years ago, 4-Mar-08, to lugnet.cad.dev)
|
|
