 | | open source & inventory ?
|
|
Hello, I've just resently discovered Ldraw and Mlcad and I'm absolutely amazed at the power of these programs, allthough I've not yet build a real model (other than the tutorial). I have got 2 questions however. 1) Are any of the programs open (...) (25 years ago, 31-Mar-00, to lugnet.cad.dev)
|
| |
| | BFC: LITS 2
|
|
Rui has stated that there are outstanding issues with the BFC proposal that are not included in the issues list at the start of that proposal. With this message, I am going to review the messages from the "Line in the Sand" thread, which started at (...) (25 years ago, 30-Mar-00, to lugnet.cad.dev)
|
| |
| | Re: Time for BFC overhaul?
|
|
(...) In lugnet.cad.dev, Rui Martins wrote: (...) I'm glad I didn't let you down. ;) (...) Because it's easier than rereading the entire thread of 83 messages where we went through all this before. Seriously. But I will attempt to go through that (...) (25 years ago, 30-Mar-00, to lugnet.cad.dev)
|
| |
| | Re: Problem with 1-4con1.dat
|
|
Steve Bliss <blisses@worldnet.att.net> wrote in message news:85s6es8rkgaqn20...4ax.com... (...) as (...) "L3P -check" (...) And will it substitute for all the cone primitives? (please,please,please) -John Van (25 years ago, 30-Mar-00, to lugnet.cad.dev)
|
| |
| | Re: Part numbers for newer parts
|
|
(...) The only generally available method of finding parts numbers is to look for the number embossed on the interior of the part. If the number for a part is unknown when a file for that part is submitted for inclusion in the official updates, (...) (25 years ago, 30-Mar-00, to lugnet.cad.dev)
|
