 | | Re: Technic Axle Joiner / Cross Block descriptions
|
|
(...) None of those parts should really be referred to as "axle joiners" or "pin joiners". The only parts that should have those names are the ones that join them end-to-end. These parts are all what a hardware store would recognize as a saddle (...) (15 years ago, 27-Jul-09, to lugnet.cad.dev)
|
| |
| | Re: Technic Axle Joiner / Cross Block descriptions
|
|
(...) See, right there I couldn't agree with you less. I spend a lot more time producing a design in LDraw than I do plugging the parts list into Bricklink, and when I'm doing so I generally have to stick to part numbers rather than descriptions (...) (15 years ago, 27-Jul-09, to lugnet.cad.dev)
|
| |
| | Re: Technic Axle Joiner / Cross Block descriptions
|
|
Most of you know my opinion on this one - use BrickLink names. Our community is dispursed enough. We need to work to unify what we can. BrickLink names are the most widely used amongst the community. After all, how many people convert their LDraw (...) (15 years ago, 24-Jul-09, to lugnet.cad.dev)
|
| |
| | Re: Technic Axle Joiner / Cross Block descriptions
|
|
(...) I agree it is time to rationalize naming of this similar parts... I would go one step further and name all of them "Technic Joiner Perpendicular xxxx" since hole type sequence is described in the end of name, and a 6536.dat Technic Axle Joiner (...) (15 years ago, 23-Jul-09, to lugnet.cad.dev)
|
| |
| | Technic Axle Joiner / Cross Block descriptions
|
|
With almost all the "Technic Axle Joiner" parts on the Parts Tracker, I'd like to take the opportunity to rationalise the part descriptions which have developed over time as these parts have appeared. Currently we have: 6536.dat Technic Axle Joiner (...) (15 years ago, 22-Jul-09, to lugnet.cad.dev)
|
