|
|
 | | Re: [Newpart] - #2871, Electric Train 9V Motor Decorative Side
|
| i know that this part is unfinished. BUT when i downluaded it some parts that by all rights should have been there were not, probobly for the same reason as my roadplates???. (26 years ago, 16-Apr-99, to lugnet.cad, lugnet.cad.dev)
| | | | | Re: Quad intersections
|
| (...) Here's what I use, it works for triangles but you can easily change it for a quad. The idea is to check the angles between the vectors formed by each vertex and the point you're testing. x,y,z: point p1,p2,p3: vertex (float[3]) double pa1[3], (...) (26 years ago, 16-Apr-99, to lugnet.cad.dev)
| | | | | Re: Abuse (was: Re: Non-TLG Parts)
|
| Steve Bliss wrote in message <3717595d.1405512@lu...et.com>... (...) Normally I would agree, but the situation has gotten to the point where I can't tell which side of the question is worse. JW certainly comes off as rough around the edges, but his (...) (26 years ago, 16-Apr-99, to lugnet.cad.dev)
| | | | | Re: Status of SW Ion Cannon?
|
| (...) I just need to make the cone at the base of the barrel. I was debating whether to include the cutout on the underside of the barrel or not. It would be a lot easier to make it a 4-4 cone. Also, it would look better in L3P/POV-Ray because then (...) (26 years ago, 16-Apr-99, to lugnet.cad.dev)
| | | | | Re: suggestion for roadplate like parts
|
| (...) That's fine, I'm willing to make the parts, but I'm not highly motivated for it. Steve (26 years ago, 16-Apr-99, to lugnet.cad.dev)
|
|
