 | | Re: New LDraw based editor... GLIDE. Click authors required.
|
|
(...) Note also that a 1x4 brick can be attached to a 2x4 brick anywhere on about 70-80 degree angle if only attached by the end stud - its only the other studs hitting the sides that restrict it. ROSCO (20 years ago, 23-Jun-04, to lugnet.cad, lugnet.cad.dev.lcd, lugnet.cad.dat.parts)
|
| |
| | Re: New LDraw based editor... GLIDE. Click authors required.
|
|
I guess I'm thinking about this differently. It's not that the individual studs on the brick don't allow other mating angles. (IE you can place a 1 x 6 technic plate with rounded ends on any single stud at some funcky angles) It's the combination of (...) (20 years ago, 23-Jun-04, to lugnet.cad, lugnet.cad.dev.lcd, lugnet.cad.dat.parts)
|
| |
| | Re: New LDraw based editor... GLIDE. Click authors required.
|
|
(...) I really like the way the .dat format reuses geometry e.g. stud.dat. I think the clicking format should be able to do the same thing. I imagine that would be quite a bit more difficult to reuse if the clicking info was in the dat files. (...) (...) (20 years ago, 23-Jun-04, to lugnet.cad, lugnet.cad.dev.lcd, lugnet.cad.dat.parts)
|
| |
| | Re: New LDraw based editor... GLIDE. Click authors required.
|
|
(...) I do indeed think it would be undesirable. As we all know Stud.dat gets used every ware. There are a fair few instances were the clicking behaviours of two bricks would be different even though they are both referencing the same stud.dat file (...) (20 years ago, 23-Jun-04, to lugnet.cad, lugnet.cad.dev.lcd, lugnet.cad.dat.parts)
|
| |
| | Re: New LDraw based editor... GLIDE. Click authors required.
|
|
(...) I agree, but in the short term, I think seperate files may be simpler. (...) I thought so too, but the format document (way at the bottom) implies that this might be undesirable. I'm not sure I understand why, though : ( (20 years ago, 22-Jun-04, to lugnet.cad, lugnet.cad.dev.lcd, lugnet.cad.dat.parts)
|
