| | Re: Ebrace and Extend (was Re: Non-commercial clause)
|
|
(...) You are corrrect. Re-submission is not required. Library changes only need to be published. [snip] (...) Agreed. It is bunch of work for just about everybody involved. However, the result is typically better than if you go off on your own. (...) (20 years ago, 6-Jun-04, to lugnet.cad.dev.org.ldraw)
|
|
| | Re: MakePart.c (Was: Baseplate generator program)
|
|
Hi, "Tore Eriksson" <tore.eriksson@mbox3...wipnet.se> schrieb im Newsbeitrag news:HywH7z.GLE@lugnet.com... (...) <SNIP> cool I'll give it a try! Thanks a lot, Michael (20 years ago, 6-Jun-04, to lugnet.cad.dev)
|
|
| | Re: Ebrace and Extend (was Re: Non-commercial clause)
|
|
(...) Understood. (...) Agreed. (...) As long as people understand the trade-offs. Adding redistribution restriction clauses is tricky and hard to get right. Frequently people can work around them. (...) It is quite possible, although I doubt that (...) (20 years ago, 6-Jun-04, to lugnet.cad.dev.org.ldraw)
|
|
| | MakePart.c (Was: Baseplate generator program)
|
|
I knew I had it somewhere... If this code snippet can be of any use, anyone is free to use it. Notes: The main() is just an example on how to call the makepart() function. The groove option does not work. There really should be an outputfilename (...) (20 years ago, 6-Jun-04, to lugnet.cad.dev)
|
|
| | Re: Baseplate generator program
|
|
Lester, I would like to include that into MLCad. Adding as a meta command for MLCad I could support this. All I would need is some sort of library I can use. Best way would be a dll, which generates that - or if you do not mind already the source (...) (20 years ago, 6-Jun-04, to lugnet.cad.dev)
|