Special:
|
[DAT] (requires LDraw-compatible viewer)
|
Subject:
|
Re: New stud 4 primitive for plates with holes
|
Newsgroups:
|
lugnet.cad.dat.parts.primitives
|
Date:
|
Tue, 12 Feb 2002 17:00:57 GMT
|
Viewed:
|
1308 times
|
| |
|
|
"Mark Kennedy" <mkennedy@peak.org> schrieb im Newsbeitrag news:GrFCoL.MzM@lugnet.com...
> Here is a new version of the stud 4 primitive for use in technic plates and
> other parts with holes in the plates. By including the ndisks into the
> primitive they can be ommited from the part thus saving space, the bad news is
> that when you turn studs to lines you get square holes in your piece. Please
> give me your opinions.
Stud4 files are in the bottom of a piece and possible they need to stretch
sometimes. So the height of the hole is not constant. So I think it's easier
to make this hole as a single part like this:
1 16 0 0 0 8 0 0 0 1 0 0 0 8 4-4edge.dat
1 16 0 3 0 6 0 0 0 0 0 0 0 6 4-4ndis.dat
1 16 0 0 0 8 0 0 0 0 0 0 0 8 4-4ndis.dat
1 16 0 3 0 6 0 0 0 0 0 0 0 6 4-4edge.dat
1 16 0 0 0 6 0 0 0 3 0 0 0 6 4-4cyli.dat
1 16 0 0 0 1 0 0 0 1 0 0 0 1 STUD4a.DAT
But I think this is not necessary.
CU Bernd
|
|
Message is in Reply To:
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
