 | | Request: Hi-res 1-4ndis.dat
|
|
Anyone? (25 years ago, 6-Jan-01, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: Duplo parts?
|
|
In lugnet.cad.dat.parts Steve Bliss wrote... (...) Yup... :) (...) There is: Primitive substitution! I found out that we (mis)use stud4.dat by scaling its height by 5 in bricks! (and other factors in other parts) If I add a rounded edge to (...) (25 years ago, 4-Jan-01, to lugnet.cad.dat.parts, lugnet.cad.dat.parts.primitives, lugnet.cad.dev)
|
| |
| | Re: Updated Primitive - 1-8t0102 1/8 torus, 1-inner Radius, 2-outer radius
|
|
Paul (et al), Sorry I haven't replied to this message, I've been meaning to, but I didn't want to rush out a quick reply without thinking things through. I'm not sure I've thought things through thoroughly, but I thought I'd at least throw this out. (...) (25 years ago, 4-Jan-01, to lugnet.cad.dat.parts.primitives)
|
| |
| | New Primitive: Stud4du.dat Duplo bottom tube [DAT]
|
|
I'm not terribly familiar with the naming conventions for parts, so I expect this will need a different name and/or filename... This is the bottom tube for Duplo parts. Note that it is not just a doubled System tube. The inner diameter is (...) (25 years ago, 4-Jan-01, to lugnet.cad.dat.parts.primitives)
|
| |
| | Re: New Primitive: Studdu2.dat Duplo Stud
|
|
This part looks good to me, although the geometry is clearly a combination between older Duplo parts and newer Duplo parts. The OD is clearly correct because it exactly doubles a System stud. You can demonstrate with a pair of plates that the space (...) (25 years ago, 4-Jan-01, to lugnet.cad.dat.parts.primitives)
|
