 | | Re: Is anyone working on 32745?
|
|
(...) I have never done in this way, but it sounds good. I think first step should be a mokup for the overall dimensions and the connection (axle hole etc) points. The fine tuning (ribs in frontside etc) should then be divided into areas for you and (...) (16 years ago, 28-Mar-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Is anyone working on 32745?
|
|
(...) Cool. We might actually get this very difficult part done. It may take a while but I'll try to get the inside bit mostly complete (easier than the outside). Then we can split the work into the harder bits... Tim PS. We should probaly shift to (...) (16 years ago, 28-Mar-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Is anyone working on 32745?
|
|
(...) I have send my first efforts already by email. cu mikeheide (16 years ago, 30-Mar-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Is anyone working on 32745?
|
|
(...) Gosh. I forgot this thread. I have been working on this part for some time now, and I have a few things done (mainly the rear half, I was going to work on front part). I hope I have not duplicated too much of your work. Could you keep me in (...) (16 years ago, 7-Nov-08, to lugnet.cad.dat.parts)
|
| |
| | Re: Is anyone working on 32745?
|
|
I'm happy to announce it is now available on parts tracker. (URL) (16 years ago, 18-Nov-08, to lugnet.cad.dat.parts)
|
