| |
I just started part 30384, the Naboo Fighter Canopy. I have a couple of
questions:
1) There is a little divvet on the nose of the canopy. This seems to be
a molding artifact, but it looks like it is a regular and prominent
one. Should this be included in the part?
2) There are molding lines at the edges between the vertical surfaces
and the curved surface, as well as between the differently sloped
sections of the curved surface. Should these lines be modeled? If so,
in what color? Or shuld they be Optional Lines?
3) I'm tenatively calling this part "Canopy, Round 4 x 7 x 2" Any
better suggestions?
--Karim
|
|
Message has 4 Replies:
 | | Re: Working on Part 30384
|
| (...) Looking at the divot, I'd say it's not crucial. It would be a nice piece of work to put it in, but a real PITA to do. (...) You don't need to model molding lines, but there should be optional lines whereever the surface bends. The cylinder (...) (26 years ago, 11-May-99, to lugnet.cad.dev)
| | | Re: Working on Part 30384
|
| Karim <knassar@mindspring.com> wrote in message news:37378F61.BEDC19...ing.com... (...) Nah. Too much trouble and it will make the piece look worse, not better. I'm going to leave it out on the X-Wing canopy as well. (...) I was considering doing (...) (26 years ago, 11-May-99, to lugnet.cad.dat.parts, lugnet.cad.dev)
| | | Re: Working on Part 30384
|
| Horray !!!! :-) and yes it should fall under the windscreen catagory. Ryan "Build or build not. There is no try." - Lego Master Yoda ***...*** REPLY SEPARATOR ***...*** (...) (26 years ago, 12-May-99, to lugnet.cad.dev)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
