Subject:
|
Re: New part: Slope Brick 33 3 x 2 with Red and Yellow Number 1 Pattern
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 23 Sep 2005 20:52:36 GMT
|
Viewed:
|
3118 times
|
| |
|
|
In lugnet.cad.dat.parts, Jaco van der Molen wrote:
> http://www.peeron.com/inv/parts/3298px31
> LMKWYT
If it goes onto the tracker, I suspect it will be held also because the part of
the one that sticks out to the left at the top doesn't stick out enough, and the
curved portion there should probably be curvier. (Note that all I can compare
it to is the peeron photo.)
--Travis Cobbs
|
|
Message is in Reply To:
4 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
