 | | Question about "stickers"
|
|
So far, the only standard I've found about modeling sticker "parts" is that they should be 0.25 LU off the surface of the piece they will be "stickered" to. What about width & length compared to the surface? I.E: sticker for shields - should they (...) (20 years ago, 12-Aug-05, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: have these pieces been CADed?
|
|
(...) It's worth noting that the parts aren't certified yet, and in fact have a hold vote in their common sub-file. So if the next official update is soon, then it's probably unlikely that these parts will be in it. --Travis (20 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: have these pieces been CADed?
|
|
(...) No, the primary PT admin (Chris Dee) has been off on holiday until recently. -Orion (20 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: have these pieces been CADed?
|
|
Let's just hope that not too much time and energy goes into this 'steering committee election thingy... (URL) (20 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: have these pieces been CADed?
|
|
(...) Read this: (URL) Niels (20 years ago, 29-Jul-05, to lugnet.cad.dat.parts, FTX)
|
