Subject:
|
Re: 9v train motor - 590.dat
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 24 May 2004 09:52:44 GMT
|
Viewed:
|
7861 times
|
| |
|
|
Hi,
I have included Anton Raves POV-code in to my 590 file. See the difference
here:
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=657625 (LDraw)
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=657626 (Raves)
Jeroen
"Mark Riley" <markril@hotmail.com> wrote in message
news:Hy6FL6.13JH@lugnet.com...
> In lugnet.cad.dat.parts, Sven Reger wrote:
> > In lugnet.cad.dat.parts, Ryan J. Schave wrote:
> > > Has anyone noticed that the hooks/pegs on the front and the back of the
> > > motor aren't where they're supposed to be? Or is that the height of • the
> > > motor is too tall.
> > >
> > > My issues below deal with the 9v train motor that came with my 3225 • classic
> > > train.
> > >
> > > I've attached a 1x4 plate to the front hooks. I then put a 1x6 brick • on top
> > > of that. The top of the 1x6 brick is then flush with the top of the • train
> > > motor (excluding the bogie plate). The 590.dat file I have seems to be
> > > different. It takes two 1x4 plates underneath the 1x6 brick to make it
> > > flush with the top of the motor.
> >
> > Hi Ryan,
> >
> > I just saw that your posting is 4 years old. And during all this time • noone
> > has ever fixed this bug in 590.dat And I'm sure it is a bug! Here is a
> > picture that shows what is wrong with this part:
> >
> >
<<http://www.brickshelf.com/gallery/kleinesteine/CAD/trainwheels/590bug.jpg>
>
> >
> > I hope that after all this time a fix can be applied for future • generations
> > ;-) The dimensions of the 9 V motor are definetly wrong.
>
> Also, I notice the technic pin on the bogie plate is shorter than it • should be -
> the dat file has it as 12 LDU tall when I measure the actual pin to be 14 • LDU
> tall. I think Ryan may have been alluding to this when he talked about • the
> height being incorrect.
>
> Could there be more than one version of the 9V train motor?
>
> Mark
|
|
Message is in Reply To:
 | | Re: 9v train motor - 590.dat
|
| (...) Also, I notice the technic pin on the bogie plate is shorter than it should be - the dat file has it as 12 LDU tall when I measure the actual pin to be 14 LDU tall. I think Ryan may have been alluding to this when he talked about the height (...) (22 years ago, 23-May-04, to lugnet.cad.dat.parts, FTX)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
