Subject:
|
Re: Improved minifig heads
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 1 Apr 2004 20:53:22 GMT
|
Viewed:
|
2374 times
|
| |
|
|
In lugnet.cad.dat.parts, Andrew Westrate wrote:
> Is there any interest in improving the minifig heads by using torus primitives?
> For some of the patterned heads, where there is printing on the curved section,
> it would be somewhat difficult, but most of them could be fixed pretty easily.
I can't comment, because I don't have that torus file (t04o6250). However, the
stuff left makes it look like the posted dat isn't correct even with the file.
(Some of the geometry that I would have expected to be replaced by the torus is
still there.)
--Travis Cobbs
|
|
Message has 1 Reply:
 | | Re: Improved minifig heads [DAT]
|
| (...) Here's the same file with the torus primitive included. The left over quads you're seeing are part of the subfile, 3626bs01.dat. I didn't do anything about that, since this is just an example. 0 FILE 3626bp01.dat 0 Minifig Head - Stud Hollow 0 (...) (21 years ago, 2-Apr-04, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Improved minifig heads [DAT]
|
| Is there any interest in improving the minifig heads by using torus primitives? For some of the patterned heads, where there is printing on the curved section, it would be somewhat difficult, but most of them could be fixed pretty easily. Andy 0 (...) (21 years ago, 1-Apr-04, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
