Subject:
|
Re: Strange thing with part 30179
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Thu, 1 Aug 2002 13:05:24 GMT
|
Viewed:
|
3776 times
|
| |
|
|
In lugnet.cad.dat.parts, Jaco van der Molen writes:
> I downloaded this unofficial part from the Parttracker including all
> subfiles:
>
> 30179.dat (Door 1 x 4 x 6 Frame)
> stud9.dat (Stud 2 Small Hole)
> x213s02.dat (~Door 1 x 4 x 6 Glass)
> x213s01.dat (~Door 1 x 4 x 6)
> x213.dat (Door 1 x 4 x 6)
>
> Now when I open 30179 in MLCad or use it in a model, I get the message
> "stu29.dat not found". I looked and I searched, but there is no use of
> "stu29.dat". The render however does not show the studs with the small holes
> on the edge of the door. But this is supposed to be "stud9.dat" and I have
> that file!
>
> What is happening here? Any suggestions?
>
> Greetingz...
>
> Sjaacko
The file Stud29 would be the fast draw version of stud9. The fast draw
version is the same as the regular version but it uses 6 sides instead of 8.
Go to Settings->General->Change... in MLCad. Click on the Rendering tab and
under Edit-Mode Options change Stud-Mode from Coarse to Normal. I think
this will fix your problem.
-Orion
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Strange thing with part 30179
|
| I downloaded this unofficial part from the Parttracker including all subfiles: 30179.dat (Door 1 x 4 x 6 Frame) stud9.dat (Stud 2 Small Hole) x213s02.dat (~Door 1 x 4 x 6 Glass) x213s01.dat (~Door 1 x 4 x 6) x213.dat (Door 1 x 4 x 6) Now when I open (...) (24 years ago, 1-Aug-02, to lugnet.cad.dat.parts)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
