Subject:
|
Re: New Part: x727 - Trailer 4 x 16 Ramp
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 15 Apr 2002 22:11:09 GMT
|
Highlighted:
|
(details)
|
Viewed:
|
1902 times
|
| |
|
|
In lugnet.cad.dat.parts, Don Heyse writes:
> Hi Tore,
>
> This one could use some edge lines at the tips of the "thumbs"
>
> It also has that problem with the optional line where the cylinder
> meets the flat surface that we talked about before.
>
> http://news.lugnet.com/cad/dat/parts/?n=3375
>
> I only mention that one because I don't think we should forget
> about the problem with the cylinder primitives...
>
> Don
I know, I know, but I couldn't care much less. The parts I make are good
enough for making instructions and overqualified for animations, but never
good enough for the authorizing crew. It's no use, I won't even try to
submit any more parts to the Tracker. There is a balance between quality and
quantity and my opinion is that this whole thing has heeled over badly to
paying attention to insignificant details.
From now on, I will only submit my parts here where people can enjoy them if
they can stand the flaws.
/Tore
PS. Don't take it personal, Don. :o) DS.
|
|
Message has 3 Replies:
 | | Re: New Part: x727 - Trailer 4 x 16 Ramp
|
| (...) Hi Tore, I'm not sure what to make of this. I think your parts are fantastic and I'm sure many people (myself included) enjoy them even with these insignificant flaws. I'd have thought your parts would have no problems with the official (...) (23 years ago, 16-Apr-02, to lugnet.cad.dat.parts)
| | | Re: New Part: x727 - Trailer 4 x 16 Ramp
|
| Tore, I know exactly how you feel. I have only submitted a few parts in my time. None of which are good enough. A few had some duplicated line and stuff, which I corrected, resubmitted and were never updated. One was ignored by people and was (...) (22 years ago, 2-Jan-03, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: New Part: x727 - Trailer 4 x 16 Ramp
|
| Hi Tore, This one could use some edge lines at the tips of the "thumbs" It also has that problem with the optional line where the cylinder meets the flat surface that we talked about before. (URL) only mention that one because I don't think we (...) (23 years ago, 15-Apr-02, to lugnet.cad.dat.parts)
|
14 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
