Subject:
|
Re: New Part - Panel 1 x 4 x 3 with Recycling Pattern
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Tue, 20 Nov 2001 17:28:23 GMT
|
Viewed:
|
1032 times
|
| |
|
|
"Chris Dee" <chris_w_dee@hotmail.com> schrieb im Newsbeitrag news:Gn2HzC.Dqz@lugnet.com...
>
> I do not believe the type 2 lines around the border of the pattern are
> necessary - type 2 lines really only serve two purposes i) to represent an edge
> between two non co-planar surfaces, and ii) to prevent fine-detailed patterns
> from becoming obscure at low magnification - and in this case the type 2 line
> should be drawn within the boundary of a quad or triangle, in the same colour.
>
> At present all other released decorated 4215 parts are complete parts with the
> non-decorated surface included (repeatedly) in each file. If this is a
> candidate for using a subpart for the non-decorated surfaces, then I think we
> should be consistent and re-work the existing 4215.dat and 4215pxx.dat files to
> use the same methodology. Is this something you could take on? We are not
> really consistent about naming such non-decorated subparts, but I think
> s\4125s01.dat would be closer to how we have done other such parts.
Good idea.
I think I could do this.
/CU
Bernd
|
|
Message is in Reply To:
4 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
