Subject:
|
Re: Panel as seen in set 1682
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 28 Jul 2001 17:41:55 GMT
|
Viewed:
|
961 times
|
| |
|
|
In lugnet.cad.dat.parts, Jaco van der Molen writes:
> Hi all,
>
> I am looking for the part that forms the hatches in the Space Shuttle like
> in set 1682. It is 3 high, 2 broad and 4 length. It has a 45 degree slope on
> top. At the bottom it can be attached to a car roof holder, or plate 1x4
> with fingers or Tile Hinge 1x4.
>
> Has it been made and what is the partsnumber?
>
> Greetingz...
>
> Sjaacko
I think your looking for one of these two parts ...
<http://www.peeron.com/inv/parts/2582>
<http://www.peeron.com/inv/parts/6139>
I believe that the parts themselves are identical, but the different numbers
have something to do with opaque vs translucent pieces.
Ray
|
|
Message has 2 Replies:
 | | Re: Panel as seen in set 1682
|
| (...) I think we figured out the difference between the two - one of them (I'm not sure which, I think the opaque version) has the sloped part of it textured, while in the other version it's smooth. I believe the dats for the two pieces are (...) (23 years ago, 28-Jul-01, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Panel as seen in set 1682
|
| Hi all, I am looking for the part that forms the hatches in the Space Shuttle like in set 1682. It is 3 high, 2 broad and 4 length. It has a 45 degree slope on top. At the bottom it can be attached to a car roof holder, or plate 1x4 with fingers or (...) (23 years ago, 28-Jul-01, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
